Repairing gas leaks and running new gas lines to appliances, outdoor living areas and detached buildings across Queen Creek
Call (480) 684-3487 NowSmell gas? Get everyone outside first. Do not use light switches, the garage door opener or anything that could spark. From a safe distance, call your gas utility's emergency number or 911. After the utility gives the all-clear, we take over the house-side repairs.
The gas piping on your property runs from the meter to the furnace, water heater, cooktop, dryer, fireplace and anything outside that burns gas. We locate leaks with a pressure test and a gas detector, repair or replace the failed section, and test the whole system again before relighting appliances.
Many Queen Creek properties have room for more than the house: a casita, a workshop, a detached garage, a pool with a heater, a built-in grill and fire feature. Each of those needs a buried line from the meter, and every line on the system has to be sized for the total demand so the furnace and water heater keep getting enough gas when everything is running.
Buried gas work starts with an Arizona 811 request so existing utilities are marked, and new gas piping is normally permitted and inspected. We plan for both as part of the job.
Test the system for leaks or total up the new appliance load
Choose pipe size, material and the route from the meter
Repair or install the line with shutoffs at each appliance
Hold test pressure, bring burners back on and soap-check fittings
The line feeding it may be too small or too long for the demand, especially if other appliances run at the same time. Resizing the line usually solves it.
Yes. It is buried from the meter or an existing line, sized for the new load and pressure-tested before use.
If a connector is kinked, corroded or decades old, replacing it is a simple step that removes a common leak point behind ranges and dryers.
Contact us today for professional service and free estimates